Coil Springs

Leaf Springs

Urethane Suspension

Car Shock Absorbers

4x4 Shock Absorbers

Xtreme Race Coils

Torsion Bars

Shackles & Pins


Lowering Blocks

GVM Upgrades

Mining and Rail


Lovells Urethane Suspension

Polyurethane has been commonly accepted as an industrial product for over 40 years, but it wasn't until 1974 that urethane was used as a replacement for rubber in automotive suspension bushing. During the intervening 25 years, the types of urethane used have changed very little. Until 1986 use of the hard grades available restricted urethane to motorsport and heavy-duty applications where ride comfort was a very low priority.

After 1986 the second grade of urethane development occurred.- softer grades evolved that permitted urethanes to be used in general passenger applications. But the key suppliers in the urethane market simply utilized the new grades, and no further research and development took place.

Consequently the common complaints that urethane makes the vehicle ride harsh was never addressed., mainly due to the fact that it was presumed that grades softer than #75 durometer could not survive in a vehicle suspension environment.

Further development in Urethane technology was made to overcome the hard ride, yet still maintain the characteristics associated with soft rubber bushings. These new grades of urethane permit the comfortable ride of rubber but with the crisp handing, geometry control and durability associated with the harder grades of urethane. This totally new technology has revolutionised the suspension industry. #75, #85 and #90 durometers have been replaced with #60, #75 and #85 - (based on the window that #60 is the softest and #90 is the hardest durometer for automotive applications)

2 YEAR / 40,000 km WARRANTY

Installation Tips

Check your urethane bush selection to ensure you have the correct component for your application. Fit the bushes to the spring/chassis mount/component prior to final installation to ensure they are the correct fit, and length. Clean all components thoroughly and remove any rust, old paint and undercoat. Check for worn, pitted or suspect parts and replace before fitting Lovells components. Use lubricant supplied. Grease all bush surfaces designed to pivot, ie. Internal bores and flange faces. DO NOT apply grease to pressed-fit surfaces or the outside surfaces of shackle bushes. When fitting leaf spring eye bushes or shackle/pin bushes it is wise to fit the bush prior to installation of the spring to ensure free movement, thus avoiding spring damage due to the shackle seizing against the bush. This is referred to as ‘shackle lock’. Tighten all bolts and nuts to manufacturers’ specification, with vehicle at normal ride height. This is referred to as ‘normalising’.


Copyright © Lovells Springs Pty Ltd 2003 - 2010

Int. Ph: +61 2 9820 6800 Int. Fax: +61 2 9820 6788

ABN 82 139 985 603